Knowledge Base
Home » Categories » Multiple Categories

How do I reset the TLA100 to send the factory default messages (or PGNs)?

You reset the TLA100 to transmit the factory default messages using Maretron's DSM250 display in the following way:

  1. Enter menu mode, scroll to "Configuration:" and press < Enter >
  2. Scroll to "Device Configuration:" and press < Enter >
  3. Scroll to the row containing the TLA100 and press < Enter >
  4. Scroll to "Reset Factory Defaults" and pressĀ < Enter > twice.

Beware that resetting factory defaults resets all settings back to factory defaults, not just the transmitted messages.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
How do I set the J2K100 configuration setting called "NMEA 2000 Transmission Instance:" using Maretron’s DSM150 or DSM250 display?
Viewed 2635 times since Thu, Jan 14, 2010
Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?
Viewed 2786 times since Thu, May 5, 2011
Is it possible to change the rate at which the SSC200 transmits NMEA 0183 sentences?
Viewed 2238 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2166 times since Tue, Jun 17, 2008
Which Martron products work with the ALM100?
Viewed 1516 times since Wed, Jun 22, 2016
I navigate using true heading and not magnetic heading; how do I use the SSC200 compass and N2KView software to view my heading in true?
Viewed 4228 times since Fri, Jul 18, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "Cold Start GPS Engine"; what is this?
Viewed 2348 times since Tue, Jun 17, 2008
When I am creating a favorite screen on the DSM150 or DSM250, I see an "Instance:" menu item; what does this mean?
Viewed 2433 times since Thu, Mar 5, 2009
How do I clear the WSO100 atmospheric pressure offset using Maretron’s DSM150 or DSM250 display?
Viewed 3035 times since Sat, Aug 2, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a WSO100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2020 times since Sat, Aug 2, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.