Hatteland Seahawk camera integration to N2KView V3

Does Maretron N2KView V3 software support Hatteland Seahawk series camera? Yes!!

Please apply the following settings to each of your Hatteland Seahawk series cameras to support video output display on devices running N2KView V3 running version 6.3.0 or later.

1. Access your Hatteland cameras configuration & setup via a browser on your computer or mobile device.
   
   
2. Make sure the Secondary#1 stream is enabled and set to MJPEG (it is disabled by default)
   
   
   
   
3. To be able to enable Basic Authentication, apply the following settings under the User Login Policy.
   
   
   
   
4. Reboot the camera through the settings
   

Once your settings have been completed, you are now able to connect/link to your N2KView V3 based products.

Please refer to the latest User Manual of N2KView for proper setup within N2KView V3.
- https://www.maretron.com/products/N2KView.php?tab=4

Contact technical support if you have any additional questions.
Toll free (866) 550-9100 or by email at Marine.Support@carlingtech.com