What firmware changes have taken place on the Maretron DSM570?

DSM570 Firmware Versions

What firmware changes have taken place on the Maretron DSM570 display?

Update your device using the N2KAnalyzer software tool.

1.8.6.3 (2022-03-16)

• Fix rolling toad trail issue on VGA resolution display
• Correct Demo icon position on VGA resolution display
• Change screen lock mode selection from buttons combination on power up to power down options selections
• Add testmode command "startup" to support startup options
• Fix rolling road crash when ellipse cannot be drawn
• Correct DCM menu display text GEL

1.8.5.2 (2021-10-07) - Not Released

• In power off state, keep internal power supply active if N2K supply voltage is less than 10V

1.8.4.6 (2021-04-21)

• Support Yaw (PGN# 127257)
• Support Generic Sensor device
• Support Standard N2K Label (PGN# 130060)
• Support Shaft Seal Temperature (15) for DD291 (Bug #4702)
• Fix annunciator stop working after deleting issue (Bug #4652)
• Add units for Force (Bug #3749)

1.8.3.2 (2020-08-14)

• Support TSM810C, TSM1210C, MBB300C configuration
• For FFM100 configuration menu, always display K-Factor as 1000 when the K-Factor on FFM100 is 1000. This fix an issue caused after load default to FFM100 and the DSM display the old K-Factor value before loading default, this issue also fixed in the FFM100 SW 1.4.1.1
• Support CLM100 SW 1.2+
• Support CLM100 configuration for Battery, Engine, Transmission, and Vessel Devices

1.8.1.2 (2018-10-15)

• Initial customer release