Knowledge Base
Home » Categories » Multiple Categories

Is it possible to turn on or off TLA100 transmitted messages (or PGNs)?

Yes, it is possible to turn on and off the TLA100 transmitted messages (or PGNs) using Maretron's DSM150, DSM200, or DSM250 display:

  1. On the display, enter menu mode, scroll to "Configuration:" and press < Enter >
  2. Scroll to "Device Configuration:" and press < Enter >
  3. Scroll to the row containing the TLA100 and press < Enter >
  4. Scroll to "NMEA 2000 PGN Enable/Disable..." and press < Enter >
  5. You will see a list of PGNs that the TLA100 transmits. Scroll to the PGN that you want to turn on or off and press < Enter >
  6. Use the < Up > or < Down > arrow keys to choose "On" or "Off" and press < Enter >
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
If the TLA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?
Viewed 2174 times since Sun, Jun 22, 2008
How do I clear the WSO100 installation offset using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3089 times since Sat, Aug 2, 2008
How do I display the SSC200 rate of turn on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2338 times since Tue, Jul 22, 2008
Is it possible to turn on or off RAA100 transmitted messages (or PGNs)?
Viewed 2582 times since Fri, Jul 11, 2008
How do I set the J2K100 configuration setting called "J1939 Diagnostic Messages:" using Maretron’s DSM150 or DSM250 display?
Viewed 2669 times since Thu, Jan 14, 2010
How do I set up my SMS100 address book using Maretron displays?
Viewed 2511 times since Thu, Jun 6, 2013
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2288 times since Sat, Jul 19, 2008
How do I display UTC from the GPS100 on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2813 times since Mon, Jun 25, 2012
How do I set the J2K100 configuration setting called "J1939 Source Address:" using Maretron’s DSM150 or DSM250 display?
Viewed 3136 times since Thu, Jan 14, 2010
How do I display the GPS100 twilight AM time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2207 times since Tue, Jun 17, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.