Knowledge Base
Home » Categories » Multiple Categories

How do I save or load a config file in N2KView?

Saving a N2KView config file to a USB device.

1. Insert a USB flash drive into an available USB port on your device.

2. From the main screen, tap to reveal the available tabs and select Commands and Settings on the right.

3. Select tab labeled Configuration.

4. Select tab labeled Save Configuration.

5. Select the Removable Disk radial button, label the file (recommend putting the date), then click Save.

6. After a few moments, you will return back to the main screen.
Your file has been saved to the USB drive successfully.

 

Loading a N2KView config file from a USB device.

1. Insert a USB flash drive into an available USB port on your device.

2. From the main screen, tap to reveal the available tabs and select Commands and Settings on the right.

3. Select tab labeled Configuration.

4. Select tab labeled Load Configuration.

5. Select the Removable Disk radial button, locate the saved configuration file on the USB drive, then click Load.

6. You will be prompted that this configuration file will now replace your current configuration. Select OK to confirm the change.

7. After a few moments, you will return back to the main screen.
Your file has been loaded from the USB drive successfully.
Please remove the USB drive from the device.

 

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
How do I install N2KView on my MacBook?
Viewed 3135 times since Fri, Jan 18, 2013
How do I upload a config to an IPG100 for mobile devices and real time cloud?
Viewed 3680 times since Tue, Oct 15, 2019
What information is available from the temperature monitor (TMP100) and can be viewed on Maretron’s displays?
Viewed 4243 times since Fri, Jun 21, 2013
Why N2K™?
Viewed 2991 times since Wed, Sep 2, 2015
How do I extract Maretron Telemetric Cloud Service data using N2KExtractor?
Viewed 2043 times since Mon, Oct 24, 2016
What firmware changes have taken place on the Maretron TSM1330C?
Viewed 1990 times since Tue, Dec 31, 2013
How do I configure a DCR100 channel to work as an annunciator for an N2KView Alert?
Viewed 3889 times since Wed, Oct 10, 2012
I see that the DCR100 has a configuration feature called Operating Mode, What does this mean?
Viewed 1960 times since Thu, Mar 23, 2017
How do I set up my SMS100 address book using Maretron displays?
Viewed 2990 times since Thu, Jun 6, 2013
How do I enable the MBB300C for HTML5?
Viewed 3755 times since Mon, Oct 15, 2018
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.