Knowledge Base
Home » Categories » Multiple Categories

Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?

Yes, it is possible to set the TLA100 to accept American standard resistive sensors using Maretron's DSM150, DSM200, or DSM250 display. Set the mode using Maretron's DSM150, DSM200, or DSM250 display in the following way:

  1. Enter menu mode, scroll to "Configuration:" and press < Enter >
  2. Scroll to "Device Configuration:" and press < Enter >
  3. Scroll to the row containing the TLA100 and press < Enter >
  4. Scroll to "Tank Level Calibration:" and press < Enter >
  5. Scroll until you find "American Standard (240-33 ohms)" and press < Enter >
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Trip log:"; what is this?
Viewed 2648 times since Sun, Jun 22, 2008
How do I display the GPS100 sunset time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2818 times since Tue, Jun 17, 2008
How do I display Tank level on a DSM410?
Viewed 2353 times since Tue, Jul 10, 2018
How do I display the GPS100 moon phase on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2944 times since Tue, Jun 17, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2671 times since Sat, Jul 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?
Viewed 2987 times since Sun, Jun 22, 2008
How do I perform a quick setup of a TLA100?
Viewed 1612 times since Tue, Apr 23, 2019
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Levels Calibration..."; what is this?
Viewed 2598 times since Mon, Jun 29, 2009
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Calibration?"; what is this?
Viewed 2872 times since Thu, Jun 19, 2008
How do I configure an EMS100 that is connected to a Yanmar engine?
Viewed 7050 times since Tue, Sep 1, 2009
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.