Knowledge Base
Home » Categories » Multiple Categories

Can Maretron’s sensor data be displayed on a Garmin network?

Yes, much of Maretron device's data can be shown on Garmin displays with “NMEA 2000” functionality. Firstly, Maretron recommends that customers verify device compatibility by reviewing the Maretron product's datasheet specifically, the transmit PGN section of the datasheet (page 2). Second, review the Chart plotters datasheet for Received PGN list for display to confirm the compatibility.

Please note: Maretron devices allow for multi message distinction to be interpreted correctly on a display for example: PGN 130314(Temperature) allows for source selection with an instance number selection. A configuration that can only be adjusted using a Maretron device interface. The device configuration can be performed using a Maretron DSM150/250/410 or our N2KAnalyzer software tool only.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Does Maretron have a interface cable for Caterpillar engine networks to the J2K100 device?
Viewed 66530 times since Tue, Apr 5, 2011
What is the default calibration setting for the TLA100?
Viewed 3621 times since Fri, Jun 20, 2008
How do I display the J2K100 engine hours on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 4458 times since Thu, Jan 14, 2010
What are the basic configurable parameters of the TLM200 and how do I configure them using a DSM250?
Viewed 3409 times since Mon, Oct 5, 2009
I see that the FPM100 has an accessory for measuring pressures in the range of -1Bar to 1 Bar. Can I use this sensor to monitor my fuel filters?
Viewed 3535 times since Thu, Dec 18, 2014
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Type:"; what is this?
Viewed 3809 times since Sun, Jun 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 3368 times since Thu, Jan 14, 2010
What information is available from the J1939 to NMEA 2000 Bridge (J2K100) and can be viewed on Maretron’s displays?
Viewed 3596 times since Mon, Jun 24, 2013
Why I can’t find a RAA100 rudder angle for display on Maretron’s DSM150, DSM200, or DSM250?
Viewed 3923 times since Fri, Jul 11, 2008
How do I make a custom NMEA 2000 cordset cable? Does Maretron offer a field attachable connector?
Viewed 13286 times since Wed, Oct 10, 2012
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.