Knowledge Base
Home » Categories » Multiple Categories

I see that the DCR100 has a configuration feature called Operating Mode, What does this mean?
Article Number: 666 | Rating: Unrated | Last Updated: Wed, Jan 24, 2018 7:21 PM

DCR100 channels have two possible operating modes: “Normal”, in which the DCR100 channel responds to standard NMEA 2000 switching commands, and “Annunciator”, in which the channel may be connected to a power source for a sounder or a light to be activated in the case of an alert generated by a DSM150, DSM410, or DSM250 display, or by N2KView software.

 
Posted - Thu, Mar 23, 2017 5:23 PM. This article has been viewed 1572 times.
Filed Under: Applications & DIY, DCR100, DSM250 (Discontinued), DSM410, MBB200C (Discontinued), MBB300C, N2KAnalyzer, N2KView, TSM1330(Discontinued), TSM1330C (Discontinued), TSM800(Discontinued), TSM800C (Discontinued)
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
What is the default calibration setting for the RAA100?
Viewed 2767 times since Fri, Jul 11, 2008
How do I set the TLA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2884 times since Fri, Jun 20, 2008
How do I display the J2K100 transmission oil temperature on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3005 times since Thu, Jan 14, 2010
How do I display the J2K100 generator average AC frequency on Maretron’s DSM150 or DSM250 display?
Viewed 3043 times since Thu, Jan 14, 2010
I see that the FPM100 has an accessory for measuring pressures in the range of -1Bar to 1 Bar. Can I use this sensor to monitor my fuel filters?
Viewed 2751 times since Thu, Dec 18, 2014
When I am creating a favorite screen on the DSM150 or DSM250, I see an "Instance:" menu item; what does this mean?
Viewed 2694 times since Thu, Mar 5, 2009
Which Maretron products are necessary in order to display apparent wind?
Viewed 3770 times since Wed, Apr 10, 2013
Do the Solid State Relays (SSRs) within the DCR100 turn off if the NMEA 2000 power is removed from the DCR100?
Viewed 2819 times since Wed, Apr 27, 2011
Can Maretron’s DSM150 or DSM250 display or N2KAnalyzer configure certain Airmar transducers?
Viewed 4358 times since Thu, Mar 31, 2011
What IP settings does Maretron recomended for the IPG100 connection to a dedicated N2KView device (DSM800 or MBB100) to work properly?
Viewed 5096 times since Thu, Mar 31, 2011
  • Icon SubscriberSubscribe to Article
  • Icon PrinterPrint Article
  • Icon EmailEmail Article to Friend
  • Icon PDFExport to PDF
  • Icon MS-WordExport to MS Word
0 (0)
Article Rating (0 Votes)
Rate this article
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.
 
Copyright© 2019 Carling Technologies. All rights reserved. Visit Carling Technologies, a partner company.