Knowledge Base
Home » Categories » Multiple Categories

How do I set the TLA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?

You set the TLA100 "Gauge Resistance, - to sender" using Maretron's DSM150, DSM200, or DSM250 display in the following way:

  1. Enter menu mode, scroll to "Configuration:" and press < Enter >
  2. Scroll to "Device Configuration:" and press < Enter >
  3. Scroll to the row containing the TLA100 and press < Enter >
  4. Scroll to "Gauge Resistance, - to sender:" and press < Enter >
  5. Scroll until you find the appropriate resistance and press < Enter >

 

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
How do I set the J2K100 configuration setting called "J1939 Source Address:" using Maretron’s DSM150 or DSM250 display?
Viewed 3597 times since Thu, Jan 14, 2010
What are the dimensions for the DSM410?
Viewed 3307 times since Thu, Jun 1, 2017
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "Cold Start GPS Engine"; what is this?
Viewed 2810 times since Tue, Jun 17, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Status?"; what is this?
Viewed 2653 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Type:"; what is this?
Viewed 3591 times since Sun, Jun 22, 2008
How do I display temperature from a TMP100 on the Maretron DSM250 Display?
Viewed 2494 times since Tue, Sep 1, 2009
If the TLA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?
Viewed 2596 times since Sun, Jun 22, 2008
How do I display Tank level on a DSM410?
Viewed 2353 times since Tue, Jul 10, 2018
I see that Maretron’s DSM150 and DSM250 displays have a SSC200 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2613 times since Thu, Jun 19, 2008
Is it possible to turn on or off J2K100 NMEA 2000 transmitted messages (or PGNs)?
Viewed 2979 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.