Knowledge Base
Home » Categories » Engine Monitoring » J2K100

I have a STEYR Engine connected to a STEYR Control Center SCC, What cable should be used to connect the J2K100?

The STEYR SCC system is J1939 compatible to a J2K100. Use the MCF-2M-D4 cable as a connection to a single or dual J2K100 segment for engine system conversion.  The MCF-2M-D4 can be connected to an unused panel mating connection originating from the SCC display's  one of two 4 pin pigtails. Details can be located at http://www.steyr-motors.com, under SCC 4/6 cylinder applications.

Attachments (1) Attachments
Related Articles RSS Feed
How do I reset the J2K100 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 3229 times since Thu, Jan 14, 2010
How do I set the J2K100 configuration setting called "NMEA 2000 Engine Instance:" using Maretron’s DSM150 or DSM250 display?
Viewed 3489 times since Thu, Jan 14, 2010
How do I set the J2K100 configuration setting called "J1939 Diagnostic Messages:" using Maretron’s DSM150 or DSM250 display?
Viewed 3059 times since Thu, Jan 14, 2010
How many J2K100s do I need if I have two engines and I would like convert the J1939 information from both engines to NMEA 2000?
Viewed 3976 times since Thu, Jan 14, 2010
I know the J2K100 receives messages from the J1939 network and subsequently transmits them over the NMEA 2000 network, but does the J2K100 transmit any messages on the J1939 network?
Viewed 3120 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 Engine Instance:"; what is this?
Viewed 2803 times since Thu, Jan 14, 2010
Does Maretron have a interface cable for Caterpillar engine networks to the J2K100 device?
Viewed 44636 times since Tue, Apr 5, 2011
What is a J2K100?
Viewed 3979 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"; what is this?
Viewed 3313 times since Thu, Jan 14, 2010
Can the J2K100 connect to third party protocol converters that support J1708 or J1587?
Viewed 11307 times since Fri, Aug 29, 2014
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.