Knowledge Base
Home » Categories » Multiple Categories

What firmware changes have taken place on the Maretron SSC300?

What firmware changes have taken place on the SSC300?

  • Corrected a problem where "SSC300" was not recognized in configuration commands sent over the NMEA 0183 interface (3707)


  • Manufacturing improvement

  • Corrected a problem where negative pitch and roll values could be incorrectly transmitted on NMEA0183 (3659)
  • Corrected a problem where the NMEA0183 interface could start with the wrong baud rate (3652) (2015-11)

  • Corrected a problem where factory defaults weren't correctly loaded
  • Corrected a problem with status notification during magnetic deviation calibration (3619)

1.0 (2015-08)

  • Initial Release
Attachments Attachments
There are no attachments for this article.
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.