Knowledge Base
Home » Categories » Electrical Monitoring and Control » DCR100

Can Non-Maretron displays control the DCR100?

Can third party (non-Maretron) controls or displays command the DCR100 to toggle whether in Switch or ALM mode?

The DCR100 reports status using the standard NMEA2000 message 127501 that any NMEA2000 display can interpret, but to command the DCR100 to change state is limited and can only be achieved using the following Maretron products:

- DSM150

- DSM250

- TSM800(C)

- TSM1330(C)

- N2KView PC

- N2KAnalyzer 2.21.3 or higher

 

 

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?
Viewed 2754 times since Thu, May 5, 2011
What is a DCR100?
Viewed 2506 times since Sat, Apr 30, 2011
Do the Solid State Relays (SSRs) within the DCR100 turn off if the NMEA 2000 power is removed from the DCR100?
Viewed 2483 times since Wed, Apr 27, 2011
Does the DCR100 provide overcurrent circuit protection?
Viewed 2601 times since Thu, Apr 28, 2011
What are the voltage specifications for each Maretron device?
Viewed 5553 times since Thu, Dec 22, 2011
The DCR100 will not allow me to switch on/off a relay channel. Why?
Viewed 2286 times since Thu, Sep 13, 2012
How do I switch a relay channel on the Maretron DCR100 using a non-Maretron display?
Viewed 1915 times since Thu, Jun 27, 2013
Can I use the DSM150 or DSM250 to configure a DCR100?
Viewed 2566 times since Tue, May 10, 2011
Can I use the DCR100 to turn on my Marine Audio Amplifier ?
Viewed 1366 times since Tue, Jul 19, 2016
Can I use the DCR100 to detect burnt out lights or burnt out loads?
Viewed 2491 times since Sat, May 7, 2011
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.