If the TLA100's operating mode is set to "NMEA 2000 & Analog Gauge", then it is important to configure the TLA100 with the gauge's resistances in order for the TLA100 to operate correctly. Please refer to the TLA100 Users Manual for a detailed description of measuring the gauge's resistance values.
Home » Categories » Multiple Categories |
I see that Maretron’s DSM150, DSM200 and DSM250 displays have TLA100 configuration settings called "Gauge Resistance, + to sender:" and "Gauge Resistance, - to sender:"; what are these? |
Article Number: 62 | Rating: Unrated | Last Updated: Sun, Jul 12, 2015 11:20 PM
|
Attachments
![]() There are no attachments for this article.
|
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3067 times since Fri, Jul 11, 2008
How do I operate the DSM250 power button?
Viewed 2679 times since Tue, Sep 1, 2009
What are the dimensions for the DSM410?
Viewed 3304 times since Thu, Jun 1, 2017
How do I show comprehensive bilge information on Maretron’s DSM150 or DSM250 displays?
Viewed 8110 times since Thu, May 30, 2013
How do I reset the DST100 trip log using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3047 times since Sun, Jun 22, 2008
How do I display the GPS100 moon phase on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2942 times since Tue, Jun 17, 2008
How do I perform a quick setup of a TLA100?
Viewed 1609 times since Tue, Apr 23, 2019
What Yanmar engine models is the EMS100 compatible with?
Viewed 19747 times since Thu, Mar 27, 2014
How do I display the SSC200 rate of turn on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2690 times since Tue, Jul 22, 2008
What firmware changes have taken place on the Maretron DSM150?
Viewed 3681 times since Wed, Apr 16, 2014
|