Knowledge Base
Home » Categories » Multiple Categories

I see that the FPM100 has an accessory for measuring pressures in the range of -1Bar to 1 Bar. Can I use this sensor to monitor my fuel filters?

Yes, the FPM100 can transmit vacuum pressure data on the NMEA2000 bus by using Maretron sensor part number PT-V-0-1BAR-01. This sensor must be installed on the vacuum side of your fuel filter to help you determine fuel filter health displayed on a Maretron DSM150/250 or N2KView.

The following image shows how fuel passes through the filter and how you can monitor filter Vacuum using the Maretron FPM100 in conjunction with the vacuum sensor PT-V-0-1BAR-01.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Can Maretron’s sensor data be displayed on a Furuno CANBUS network?
Viewed 4622 times since Mon, Jun 12, 2017
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2844 times since Sat, Jul 19, 2008
How do I set the J2K100 configuration setting called "J1939 Source Address:" using Maretron’s DSM150 or DSM250 display?
Viewed 3815 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Installation Offset Calibration?"; what is this?
Viewed 2873 times since Thu, Jun 19, 2008
Is the FPM100 or CLM100 compatible with non-Maretron 4-20 mA pressure transducers?
Viewed 4203 times since Tue, May 10, 2011
How do I display the GPS100 moon phase on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3129 times since Tue, Jun 17, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"; what is this?
Viewed 3533 times since Thu, Jan 14, 2010
How do I set the TLA100 tank number or instance using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3399 times since Fri, Jun 20, 2008
How do I operate the DSM250 backlights?
Viewed 2845 times since Tue, Sep 1, 2009
How do I display the GPS100 Speed Over Ground (SOG) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2775 times since Tue, Jun 17, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.