English The J2K100 has a compatible connection to the MAN engine interface found on the engine interface port of most MAN CLC6.3-6.5 engine displays.
We have observed that our customers interface the J2K100 in parallel to the display using a standard micro tee connector. Please refer to the recommended interface point highlighted red in the image below.
For a complete parts list required for NMEA 2000 integration, please see the attachment category below.
The image below shows an NMEA 2000 Network connection to a MAN CLC 6.5 engine:
| Home » Categories » Engine Monitoring » J2K100 |
How do I connect the J2K100 to a MAN CLC 6.3 or 6.5 engine display? |
|
Article Number: 566 | Rating: Unrated | Last Updated: Thu, Jul 30, 2015 9:55 PM
|
Attachments (2)
|
Related Articles 
How do I display the J2K100 generator average AC frequency on Maretron’s DSM150 or DSM250 display?
Viewed 2355 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2118 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 Transmission Instance:"; what is this?
Viewed 1699 times since Thu, Jan 14, 2010
How do I perform J2K100 quick setup using the N2KAnalyzer program?
Viewed 4934 times since Wed, Oct 10, 2012
How do I display the J2K100 generator average line-neutral AC RMS voltage on Maretron’s DSM150 or DSM250 display?
Viewed 2658 times since Thu, Jan 14, 2010
I have a STEYR Engine connected to a STEYR Control Center SCC, What cable should be used to connect the J2K100?
Viewed 1997 times since Mon, Mar 28, 2016
Is J1939 similar to NMEA 2000 in that the J1939 network requires terminators?
Viewed 2266 times since Thu, Jan 14, 2010
What is a J2K100?
Viewed 2580 times since Thu, Jan 14, 2010
How is J1939 different from NMEA 2000?
Viewed 7586 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2155 times since Thu, Jan 14, 2010
|
2.23 KB ) 
Subscribe to Article
Print Article
Email Article to Friend
Export to PDF
Export to MS Word