The DCR100 has a DC current calibration option. If you have connected a DC load to a channel of the DCR100 and have not performed the "Current Sensor Zero Offset Calibration", this may affect the command of this channel especially if the DCR100 detects a negative DC current value to the load.
You can perform the DCR100 "Current Sensor Zero Offset Calibration" within the Advanced Configuration menu of the DCR100, as shown int eh following image:
The following image shows how to perform the "Current Sensor Zero Offset Configuration" using the DSM150 or DSM250.
Home » Categories » Electrical Monitoring and Control » DCR100 |
The DCR100 will not allow me to switch on/off a relay channel. Why? |
Article Number: 554 | Rating: Unrated | Last Updated: Wed, Jul 29, 2015 7:19 PM
|
Attachments
![]() There are no attachments for this article.
|
Does the DCR100 provide overcurrent circuit protection?
Viewed 3178 times since Thu, Apr 28, 2011
I see N2KView offers a component for "Indicator Status"; what products can I use to show Indicator Status?
Viewed 3084 times since Fri, Mar 27, 2015
Using N2KAnalyzer, how do I recover a Maretron device?
Viewed 4596 times since Thu, Dec 22, 2011
What are the voltage specifications for each Maretron device?
Viewed 7576 times since Thu, Dec 22, 2011
What firmware changes have taken place on the Maretron DCR100?
Viewed 3598 times since Fri, Jul 19, 2013
Do the Solid State Relays (SSRs) within the DCR100 turn off if the NMEA 2000 power is removed from the DCR100?
Viewed 3041 times since Wed, Apr 27, 2011
What type of solderless connector is ideal for connecting sensor wire to Maretron multi-channel products?
Viewed 4283 times since Wed, Oct 19, 2011
Can I use the DSM150 or DSM250 to configure a DCR100?
Viewed 3118 times since Tue, May 10, 2011
Can Non-Maretron displays control the DCR100?
Viewed 2680 times since Mon, Jul 13, 2015
Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?
Viewed 3335 times since Thu, May 5, 2011
|