Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

What type of solderless connector is ideal for connecting sensor wire to Maretron multi-channel products?

Article Number: 538 | Rating: 5/5 from 1 votes | Last Updated: Tue, Jul 28, 2015 8:51 PM

A #4 Nylon Double-Crimp Insulated Ring Terminal(P/N:WT-651045) is the ideal choice when connecting sensor wire to any of Maretron's multi channel devices.

The following link provides a great color selection to choose from: http://www.wiringproducts.com/contents/en-us/d53.html#p622

- Mike Voorhees from Yacht Masters Northwest contributed this information to help others installing Maretron equipment.

Attachments

Attachments

There are no attachments for this article.

Related Articles

What 3-Phase applications is the ACM100 compatible with?

Viewed 1407 times since Mon, Aug 9, 2010

What firmware changes have taken place on the Maretron SIM100?

Viewed 2620 times since Thu, Aug 29, 2013

Can I use the RIM100 to indicate "Water In Fuel"?

Viewed 2544 times since Tue, Oct 19, 2010

What is a DCM100?

Viewed 2455 times since Fri, Nov 7, 2008

What is the SMS100 Status message? Which Maretron components do I need?

Viewed 3415 times since Thu, Jun 6, 2013

How much current does the Maretron Smoke/Heat Detector (part # SH-002) draw from a power source?

Viewed 3143 times since Tue, Oct 12, 2010

Is it possible to wire a manual override switch around the DCR100?

Viewed 11088 times since Tue, Apr 26, 2011

Does Maretron offer quick setup instructions for the FFM100 in a dual diesel engine application?

Viewed 536 times since Mon, Jun 24, 2019

What firmware changes have taken place on the Maretron DCM100 DC Monitor?

Viewed 2570 times since Wed, Jan 18, 2012

Where would I use a DCM100?

Viewed 2577 times since Fri, Nov 7, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.