Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

Can I use the DSM150 or DSM250 to configure a DCR100?

Article Number: 529 | Rating: Unrated | Last Updated: Mon, Dec 1, 2014 7:05 PM

Yes, you can use a DSM150 or DSM250 to configure a DCR100. Please watch the following video to see how it's done.

Attachments

Attachments

There are no attachments for this article.

Related Articles

How do I display the J2K100 generator average line-line AC voltage on Maretron’s DSM150 or DSM250 display?

Viewed 2850 times since Thu, Jan 14, 2010

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Variation Source:"; what is this?

Viewed 2376 times since Thu, Jun 19, 2008

Do the Solid State Relays (SSRs) within the DCR100 turn off if the NMEA 2000 power is removed from the DCR100?

Viewed 2483 times since Wed, Apr 27, 2011

Why does the SSC200 rate of turn indicate that I am turning when I am not turning?

Viewed 2135 times since Thu, Jun 19, 2008

Is it possible to turn on or off SSC200 NMEA 2000 transmitted messages (or PGNs)?

Viewed 2315 times since Mon, Jun 25, 2012

Can I set the TLA100 to accept the European standard for resistance values (i.e. 10 to 180 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2155 times since Thu, Jun 19, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Number:"; what is this?

Viewed 2618 times since Thu, Jun 19, 2008

What information is available from the temperature monitor (TMP100) and can be viewed on Maretron’s displays?

Viewed 3500 times since Fri, Jun 21, 2013

How do I display the GPS Course Over Ground (COG) using Maretron’s DSM150 or DSM250 display?

Viewed 3404 times since Tue, Jun 17, 2008

Does Maretron offer quick setup instructions for the FFM100 in a single diesel engine application?

Viewed 5219 times since Tue, Jul 29, 2014

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.