Knowledge Base
Home » Categories » Electrical Monitoring and Control » DCR100

Can I use the DCR100 to switch AC loads?

You can not use the DCR100 to directly switch AC loads, but you can use the DCR100 with an external relay to turn On and Off AC loads.

- A Solid State Relay (SSR) can be used to switch an AC load as shown in the illustration below.

Attachments (2) Attachments
Related Articles RSS Feed
Can I use the DCR100 to turn on my Marine Audio Amplifier ?
Viewed 2554 times since Tue, Jul 19, 2016
What is a DCR100?
Viewed 3131 times since Sat, Apr 30, 2011
Is it possible to wire a manual override switch around the DCR100?
Viewed 17113 times since Tue, Apr 26, 2011
What type of solderless connector is ideal for connecting sensor wire to Maretron multi-channel products?
Viewed 4281 times since Wed, Oct 19, 2011
Can I use the DSM150 or DSM250 to configure a DCR100?
Viewed 3118 times since Tue, May 10, 2011
Does the DCR100 provide overcurrent circuit protection?
Viewed 3178 times since Thu, Apr 28, 2011
Can Non-Maretron displays control the DCR100?
Viewed 2679 times since Mon, Jul 13, 2015
Using N2KAnalyzer, how do I recover a Maretron device?
Viewed 4592 times since Thu, Dec 22, 2011
What type of information can be viewed on Maretron’s display products, and what products are required to generate the data to be displayed?
Viewed 24629 times since Tue, Oct 25, 2011
The DCR100 will not allow me to switch on/off a relay channel. Why?
Viewed 3355 times since Thu, Sep 13, 2012
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.