Knowledge Base
Home » Categories » Multiple Categories

Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?

Yes, you can turn On and Off loads connected to the DCR100 using the DSM150 or DSM250. To do so, you should understand a few things about the DSM150 or DSM250 and its favorite screens. First, you need to understand how to setup a favorite screen within the DSM150 or DSM250 and second, you need to understand how to place the DSM150 or DSM250 into "Control" mode for actually turning circuits On and Off. Please watch the first video to learn how to setup up a favorite screen that contains switch components for turning On and Off circuits. Please watch the second video to learn how to control the switch components contained on a favorite screen.

 

 

 

 

 

 

Attachments (2) Attachments
Related Articles RSS Feed
How do I display the J2K100 engine oil temperature on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2670 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a WSO100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 1868 times since Sat, Aug 2, 2008
When I am creating a favorite screen on the DSM150 or DSM250, I see an "Instance:" menu item; what does this mean?
Viewed 2255 times since Thu, Mar 5, 2009
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Type:"; what is this?
Viewed 2549 times since Sun, Jun 22, 2008
How do I set the RAA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2358 times since Thu, Jul 10, 2008
How do I display the DC Time Remaining on the DSM150 or DSM250 display?
Viewed 2330 times since Fri, Nov 7, 2008
How do I clear the WSO100 installation offset using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2811 times since Sat, Aug 2, 2008
How do I display a SIM100 channel on the Maretron DSM250?
Viewed 2642 times since Wed, Dec 23, 2009
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 1883 times since Fri, Jun 20, 2008
Can I set the TLA100 to accept the European standard for resistance values (i.e. 10 to 180 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2009 times since Thu, Jun 19, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.