Knowledge Base
Home » Categories » Multiple Categories

How do I set up the EMS100 for my Yanmar engine?

In order to setup an EMS100 several things must be known.

  1. What senders have been installed on the engine?
  2. What type of engine gauge panel is installed with the engine?
  3. Where is the factory interface available for the EMS100 engine harness to tee into?

Once the EMS100 is installed and connected to the NMEA2000 bus you will need to power the engines on in-order to access the EMS100 using a DSM150 or DSM250 display.

Under the "Device Configuration" list select the EMS100.
Review the calibration options for the EMS100 and configure the device to match the Yanmar installation. Refer to the attachments at the bottom of this page for details. Note: New VDO-type tachometer gauges connect to the alternator signal. The EMS100 can be configured for the newer type tachometer by simply adjusting the tooth count.




Attachments (2) Attachments
Related Articles RSS Feed
Can Maretron’s sensor data be displayed on a Furuno CANBUS network?
Viewed 1402 times since Mon, Jun 12, 2017
I see that Maretron’s DSM150, DSM200 and DSM250 displays have a WSO100 configuration setting called "Installation Offset Calibration..."; what is this?
Viewed 2772 times since Mon, Jul 21, 2008
How do I display the J2K100 engine fuel rate on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2879 times since Thu, Jan 14, 2010
How do I set the TLA100 configuration setting called "Gauge Resistance, + to sender:" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2247 times since Mon, Jun 25, 2012
How do I calibrate the SSC200 pitch to read zero using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2269 times since Fri, Jul 18, 2008
How do I display the J2K100 transmission oil temperature on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2522 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Calibration?"; what is this?
Viewed 2176 times since Thu, Jun 19, 2008
Which Maretron products are required for me to display true wind referenced to ground speed?
Viewed 4669 times since Wed, Apr 10, 2013
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Installation Offset Calibration?"; what is this?
Viewed 2027 times since Thu, Jun 19, 2008
Can I set the RAA100 to accept the European standard for resistance values (i.e. 10 to 180 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2305 times since Thu, Jul 10, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.