Knowledge Base
Home » Categories » Tank Monitoring » TLA100

What is a TLA100?

The TLA100 is a tank level adapter that converts an analog resistive tank sender into digital information, which is then broadcast over the NMEA 2000 where any NMEA 2000 compatible display can show the tank level. Once properly configured, the TLA100 can also transmit the fluid type and the capacity of the tank. The TLA100 can be used with or without analog gauges and it can be calibrated for odd-sized tanks making it the most versatile tank level adapter on the market today.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Operating Mode:"; what is this?
Viewed 2236 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Number:"; what is this?
Viewed 2593 times since Thu, Jun 19, 2008
If the TLA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?
Viewed 2027 times since Sun, Jun 22, 2008
How do I perform a quick setup of a TLA100?
Viewed 534 times since Tue, Apr 23, 2019
Why doesn’t my tank display doesn’t read full when the tank is full?
Viewed 2040 times since Thu, Jun 19, 2008
How do I set the TLA100 configuration setting called "Gauge Resistance, + to sender:" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2422 times since Mon, Jun 25, 2012
If the TLA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?
Viewed 1696 times since Fri, Jun 20, 2008
Can I use the TLA100 if I don’t have a rectangular tank?
Viewed 1756 times since Thu, Jun 19, 2008
Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2102 times since Fri, Jun 20, 2008
How do I set the TLA100 tank type using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2595 times since Fri, Jun 20, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.