Knowledge Base
Home » Categories » Multiple Categories

What firmware changes have taken place on the Maretron DCM100 DC Monitor?

What firmware changes have taken place on the Maretron DCM100 DC Monitor? 

Update your device today using the N2KAnalyzer software tool.

 

DCM100 Firmware Revisions

 

1.0.5.2 (2015-03-06)

- Changed the default value of Time Remaining Floor from 0% to 50% for Lead-Acid batteries, and from 0% to 5% for NiCad and NiMH batteries

- Changed supported NMEA 2000 database version to 2.000

- Corrected a problem where the time remaining was transmitted incorrectly when the calculated time remaining was zero

- Corrected a problem where the time remaining could be transmitted incorrectly under very specific timing conditions

- Corrected a problem where battery state of charge could be under calculated during extremely high current drain (could go to zero sooner than expected)

 

1.0.4 (2009-02-23)

- Improved support for labeling of the device and its channels to store more pertinent information

- Made the rate of transmission of periodically transmitted messages programmable. This allows you to speed up or slow down the transmission of messages from the device to meet system needs

 

 

1.0.3 (2008-12-11)

- Added support for labeling of the device and its channels with N2KAnalyzer or DSM250. This enables the user to associate a unique text label with the DCM100 to more easily identify it on the network

- Added support for battery banks with capacity in excess of 800 AH

- Corrected an issue where current or voltage displayed values could be out of range under certain conditions

 

 

1.0.2 (2008-05-15)

- Corrected a problem where state of charge in PGN 127506 could read > 100% in certain cases

 

 

1.0.1 (2008-04-24)

- Initial public release

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
Does Maretron offer a quick setup guide for the DCM100?
Viewed 2919 times since Tue, Sep 4, 2012
Can Maretron devices be displayed on a Raymarine Seatalk NG network?
Viewed 7511 times since Wed, Feb 25, 2015
What is the maximum voltage the DCM100 can sense?
Viewed 2582 times since Fri, Oct 15, 2010
Where would I use a DCM100?
Viewed 3591 times since Fri, Nov 7, 2008
How do I display the DC Ripple Voltage on the DSM250 display?
Viewed 3092 times since Fri, Nov 7, 2008
What is a DCM100?
Viewed 3566 times since Fri, Nov 7, 2008
What information does the DCM100 provide over the NMEA 2000 network?
Viewed 3561 times since Fri, Nov 7, 2008
How do I set the DCM100 configuration setting called "Instance:" using Maretron’s DSM250 display?
Viewed 3561 times since Fri, Nov 7, 2008
What are the dimensions of the DCM100 current transducers?
Viewed 2825 times since Tue, Nov 27, 2012
Can Maretron’s sensor data be displayed on a Furuno CANBUS network?
Viewed 4478 times since Mon, Jun 12, 2017
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.