Knowledge Base
Home » Categories » Multiple Categories

How do I clear the WSO100 outside temperature offset using Maretron’s DSM150 or DSM250 display?

You clear the WSO100 outside temperature offset using Maretron's DSM150 or DSM250 display in the following way:

  1. Enter menu mode, scroll to "Configuration…" and press < Enter >
  2. Scroll to "Device Configuration…" and press < Enter >
  3. Scroll to the row containing the WSO100 and press < Enter >
  4. Scroll to "Restore Factory Defaults" and press < Enter > twice.

Beware that resetting factory defaults resets all settings back to factory defaults, not just the outside temperature.

Attachments (2) Attachments
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"; what is this?
Viewed 2545 times since Thu, Jan 14, 2010
I see that the FPM100 has an accessory for measuring pressures in the range of -1Bar to 1 Bar. Can I use this sensor to monitor my fuel filters?
Viewed 2098 times since Thu, Dec 18, 2014
How do I display a SIM100 channel on the Maretron DSM250?
Viewed 2667 times since Wed, Dec 23, 2009
How do I display the J2K100 transmission gear on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2468 times since Thu, Jan 14, 2010
How do I clear the DST100 Speed Through Water (STW) calibration using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2431 times since Mon, Aug 4, 2008
How do I calibrate the SSC200 pitch to read zero using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2350 times since Fri, Jul 18, 2008
How do I display the GPS100 moon phase on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2345 times since Tue, Jun 17, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Transducer Depth Offset:"; what is this?
Viewed 2901 times since Mon, Jun 25, 2012
Using N2KAnalyzer, how do I recover a Maretron device?
Viewed 2381 times since Thu, Dec 22, 2011
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Speed Calibration..."; what is this?
Viewed 2367 times since Sun, Jun 22, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.