You display temperature from a TMP100 using the DSM250 in the following way. Enter menu mode (press the enter or far right hand button), scroll to "Favorite Screen Setup…" and press enter. Scroll to the favorite screen where you would like to view the temperature channel and press enter. Scroll to data and press enter. Scroll to "temperature", and press enter. Scroll to the source you wish to display and press enter. Press enter again to select the type "numeric?" or "gauge?" and press enter. Press enter again for "Instance" scroll to the appropriate instance you wish to display and press enter. Press the back key three times to exit menu mode and return to the normal viewing mode. Scroll through your screens to the Favorite Screen you selected for Temperature.
(Note: if a label was created for the channel you are attempting to display, the label would be visible in brackets next to the instance number. If a label was created but is not visible at this stage then your configuration is invalid. You may need to repeat your channel setup prior to completing a favorite screen.)
Home » Categories » Multiple Categories |
How do I display temperature from a TMP100 on the Maretron DSM250 Display? |
Article Number: 362 | Rating: Unrated | Last Updated: Thu, Jun 15, 2017 10:54 PM
|
Attachments (1)
![]()
|
What type of tank senders does the TLA100 work with?
Viewed 3039 times since Fri, Jun 20, 2008
How do I set the TLA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3305 times since Fri, Jun 20, 2008
What type of information can be viewed on Maretron’s display products, and what products are required to generate the data to be displayed?
Viewed 24617 times since Tue, Oct 25, 2011
How do I make the SSC200 agree with other compasses on the vessel, or, in other words, how do I align the SSC200 with the boat?
Viewed 2844 times since Mon, Jun 25, 2012
What temperature probes are compatible with Maretron’s Temperature Monitor (TMP100)?
Viewed 27953 times since Fri, Nov 30, 2012
Why does the SSC200 rate of turn indicate that I am turning when I am not turning?
Viewed 2584 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Status?"; what is this?
Viewed 2652 times since Thu, Jun 19, 2008
Using N2KAnalyzer, how do I recover a Maretron device?
Viewed 4588 times since Thu, Dec 22, 2011
How do I reset the TLA100 to send the factory default messages (or PGNs)?
Viewed 2541 times since Fri, Jun 20, 2008
How do I display Tank level on a DSM410?
Viewed 2346 times since Tue, Jul 10, 2018
|