You configure a channel on the TMP100 in the following way. Enter menu mode, scroll to "Configuration?" and press enter. Scroll to "Device Configuration?" and press enter. Scroll to the row containing TMP100 and press enter. Select one of six channels and press enter. Select instance press enter. Scroll until you find the appropriate instance and press enter.Select "Source?" and press enter.
Scroll until you find the appropriate source and press enter. Select "Label?" and press enter. Using the available categories you will be able to create your label. If you are satisfied with the label you have created select "Save and Exit" to complete your label.
Home » Categories » Multiple Categories |
How do I configure a channel on the TMP100 using Maretron’s DSM250? |
Article Number: 361 | Rating: Unrated | Last Updated: Fri, May 23, 2014 10:35 PM
|
Attachments (1)
![]()
|
Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?
Viewed 3503 times since Thu, May 5, 2011
Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2795 times since Fri, Jun 20, 2008
What firmware changes have taken place on the Maretron DSM250?
Viewed 4313 times since Wed, Apr 16, 2014
What is the procedure for testing the ALM100 Annunciator?
Viewed 4819 times since Thu, Jan 8, 2015
Is it possible to turn on or off GPS100 NMEA 2000 transmitted messages (or PGNs)?
Viewed 2969 times since Tue, Jun 17, 2008
How do I display the J2K100 engine percent load on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3522 times since Thu, Jan 14, 2010
Can Maretron’s sensor data be displayed on a Furuno CANBUS network?
Viewed 4567 times since Mon, Jun 12, 2017
I see that Maretron’s DSM150, DSM200 and DSM250 displays have a WSO100 configuration setting called "Installation Offset Calibration..."; what is this?
Viewed 4318 times since Mon, Jul 21, 2008
What Yanmar engine models is the EMS100 compatible with?
Viewed 22181 times since Thu, Mar 27, 2014
How do I set the RAA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3196 times since Thu, Jul 10, 2008
|