Knowledge Base
Home » Categories » Multiple Categories

How do I set the WSO100 wind damping period using Maretron’s DSM250 display?

You set the WSO100 wind damping period using Maretron's DSM150 or DSM250 display in the following way:

  1. Enter menu mode, scroll to "Configuration…" and press < Enter >
  2. Scroll to "Device Configuration…" and press < Enter >
  3. Scroll to the row containing the WSO100 and press < Enter >
  4. Scroll to "Wind Data Damping Period:" and press < Enter >
  5. Set the damping period lower to see very quick changes in wind speed and direction or set the period higher to smooth out wind readings. The damping period is actually a moving average filter so you must be careful not to set the period to high because this introduces latency or delay in the reported wind speed and direction.
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 1992 times since Tue, Jun 17, 2008
How do I set the J2K100 configuration setting called "NMEA 2000 Transmission Instance:" using Maretron’s DSM150 or DSM250 display?
Viewed 2427 times since Thu, Jan 14, 2010
How do I clear the DST100 Speed Through Water (STW) calibration using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2407 times since Mon, Aug 4, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Trip log:"; what is this?
Viewed 2042 times since Sun, Jun 22, 2008
How do I display the J2K100 engine coolant pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2546 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150 and DSM250 displays have a SSC200 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2033 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a WSO100 configuration setting called "Outside Temperature:"; what is this?
Viewed 2484 times since Mon, Jun 25, 2012
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?
Viewed 2372 times since Sun, Jun 22, 2008
How do I display the WSO100 outside humidity on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2197 times since Thu, Jul 10, 2008
How do I display the GPS100 twilight AM time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 1966 times since Tue, Jun 17, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.