Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

I see that Maretron’s DSM150 and DSM250 displays have a DCM100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?

Article Number: 349 | Rating: Unrated | Last Updated: Fri, Jul 17, 2015 4:52 AM

Maretron's DSM150 and DSM250 displays have a DCM100 configuration setting called "NMEA 2000 PGN Enable/Disable…", which is used to turn on and off specific messages that are transmitted by the DCM100.

Attachments (1)

Attachments

DCM100UM_1.0.pdf ( 458 Views, 0 Bytes )

Related Articles

I see that Maretron’s DSM150 and DSM250 displays have a DCM100 configuration setting called "Instance:"; what is this?

Viewed 2307 times since Fri, Nov 7, 2008

How do I display DC Voltage on the DSM250 display?

Viewed 2053 times since Fri, Nov 7, 2008

How do I display the DC State of Health on the DSM250 display?

Viewed 1875 times since Fri, Nov 7, 2008

What is the SMS100 Status message? Which Maretron components do I need?

Viewed 3415 times since Thu, Jun 6, 2013

I see that Maretron’s DSM250 displays have a DCM100 configuration setting called "Reset Factory Defaults"; what is this?

Viewed 2481 times since Fri, Nov 7, 2008

How do I display the DC Time Remaining on the DSM150 or DSM250 display?

Viewed 2355 times since Fri, Nov 7, 2008

Can Maretron devices be displayed on a Raymarine Seatalk NG network?

Viewed 3702 times since Wed, Feb 25, 2015

Does Maretron offer a quick setup guide for the DCM100?

Viewed 1944 times since Tue, Sep 4, 2012

How do I display the DC Ripple Voltage on the DSM250 display?

Viewed 2376 times since Fri, Nov 7, 2008

How do I set the DCM100 configuration setting called "Instance:" using Maretron’s DSM250 display?

Viewed 2422 times since Fri, Nov 7, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.