Knowledge Base
Home » Categories » Electrical Monitoring and Control » DCM100

With regards to the DCM100, where should I connect the ring terminal of temperature sensor (part number TR3K)?
Article Number: 312 | Rating: Unrated | Last Updated: Mon, Jun 2, 2014 8:51 PM

You should connect the ring terminal on the Temperature Sensor to the negative terminal of the DC source being monitored.
Posted - Mon, Jun 29, 2009 7:24 PM. This article has been viewed 2379 times.
Filed Under: DCM100
Attachments (1) Attachments
Related Articles RSS Feed
How do I set the DCM100 configuration setting called "Instance:" using Maretron’s DSM250 display?
Viewed 2532 times since Fri, Nov 7, 2008
How do I display the DC Temperature on the DSM250 display?
Viewed 1863 times since Fri, Nov 7, 2008
What is the SMS100 Status message? Which Maretron components do I need?
Viewed 3569 times since Thu, Jun 6, 2013
What is the maximum voltage the DCM100 can sense?
Viewed 1997 times since Fri, Oct 15, 2010
How do I display the DC Time Remaining on the DSM150 or DSM250 display?
Viewed 2461 times since Fri, Nov 7, 2008
What messages (or PGNs) does the DCM100 transmit?
Viewed 2707 times since Fri, Nov 7, 2008
What information does the DCM100 provide over the NMEA 2000 network?
Viewed 2650 times since Fri, Nov 7, 2008
What are the dimensions of the DCM100 current transducers?
Viewed 2072 times since Tue, Nov 27, 2012
How do I display DC Current on the Maretron’s DSM250 display?
Viewed 2173 times since Fri, Nov 7, 2008
What are the voltage specifications for each Maretron device?
Viewed 5494 times since Thu, Dec 22, 2011
  • Icon SubscriberSubscribe to Article
  • Icon PrinterPrint Article
  • Icon EmailEmail Article to Friend
  • Icon PDFExport to PDF
  • Icon MS-WordExport to MS Word
0 (0)
Article Rating (0 Votes)
Rate this article
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.
 
Copyright© 2019 Carling Technologies. All rights reserved. Visit Carling Technologies, a partner company.