Knowledge Base
Home » Categories » Electrical Monitoring and Control » DCM100

What features does the DC/Battery Monitor (DCM100) have?

The Maretron DCM100 has the following features.

  • NMEA 2000® Interface
  • Waterproof Connectors
  • Sealed Waterproof Enclosure
  • Opto-Isolated from NMEA 2000® Eliminating Potential Ground Loops
  • Can monitor DC Power Sources, Transmitting Voltage and Current
  • Can monitor Lead Acid and Gel Batteries, Transmitting Voltage, Current, Temperature, and State of Charge
  • Uses Peukert's Constant and Charge Efficiency Factor for Accurate State of Charge Calculation
  • Can Calculate Charge Efficiency Factor Based on Observed Battery Performance
Attachments (1) Attachments
Related Articles RSS Feed
How do I display the DC State of Health on the DSM250 display?
Viewed 1991 times since Fri, Nov 7, 2008
How do I reset the DCM100 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 2165 times since Fri, Nov 7, 2008
What is a DCM100?
Viewed 2600 times since Fri, Nov 7, 2008
What is the maximum voltage the DCM100 can sense?
Viewed 2022 times since Fri, Oct 15, 2010
How do I display DC Current on the Maretron’s DSM250 display?
Viewed 2199 times since Fri, Nov 7, 2008
Can Maretron’s sensor data be displayed on a Garmin network?
Viewed 3738 times since Mon, Jun 12, 2017
Using N2KAnalyzer, how do I recover a Maretron device?
Viewed 2697 times since Thu, Dec 22, 2011
I see that Maretron’s DSM150 and DSM250 displays have a DCM100 configuration setting called "Instance:"; what is this?
Viewed 2431 times since Fri, Nov 7, 2008
What is the SMS100 Status message? Which Maretron components do I need?
Viewed 3615 times since Thu, Jun 6, 2013
How do I display the DC Time Remaining on the DSM150 or DSM250 display?
Viewed 2490 times since Fri, Nov 7, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.