The MCF-2M-D12CAT cable is used to interface a J2K100 to a CAT marine power display. It is recommended that the MCF-2M-D12CAT cable should connect to one of two ports on the CAT display. The ideal connection should be the occupied twelve pin connector. (Note: some CAT marine power displays have duel twelve pin connectors) To avoid damaging the CAT displays, be certain that the engines are not running when you perform this install. To start, Simply, remove existing connector from the back of the CAT display, connect the MCF-2M-D12CAT cable to that female connection. Re-connect the original CAT twelve pin connection to the available female port on the MCF-2M-D12CAT cable. Once you complete the install of the MCF-2M-D12CAT cable, connect the J2K100.
Home » Categories » Multiple Categories |
Does Maretron have a interface cable for Caterpillar engine networks to the J2K100 device? |
Article Number: 306 | Rating: 3.7/5 from 3 votes | Last Updated: Tue, Oct 10, 2017 6:20 PM
|
Attachments (1)
![]()
|
Can I use the J2K100 together with Onan generators?
Viewed 3033 times since Thu, Jan 14, 2010
How do I check the health of my NMEA 2000 cabling before powering my network?
Viewed 57374 times since Mon, Sep 12, 2011
How do I display the J2K100 generator average line-neutral AC RMS voltage on Maretron’s DSM150 or DSM250 display?
Viewed 3575 times since Thu, Jan 14, 2010
How do I display the J2K100 engine boost pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3726 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 3116 times since Thu, Jan 14, 2010
What are the voltage specifications for each Maretron device?
Viewed 7566 times since Thu, Dec 22, 2011
If I use the J2K100 with my Onan generator that has a power rating between 40-99kW, what data can I expect to see on the NMEA 2000 network?
Viewed 3123 times since Thu, Jan 14, 2010
How do I set the J2K100 configuration setting called "NMEA 2000 Engine Instance:" using Maretron’s DSM150 or DSM250 display?
Viewed 3489 times since Thu, Jan 14, 2010
How do I display the J2K100 generator average line-line AC voltage on Maretron’s DSM150 or DSM250 display?
Viewed 3407 times since Thu, Jan 14, 2010
How do I make a custom NMEA 2000 cordset cable? Does Maretron offer a field attachable connector?
Viewed 12446 times since Wed, Oct 10, 2012
|