Knowledge Base
Home » Categories » NMEA 2000 Gateways/Bridges » USB100

Does the USB100 convert NMEA 2000 engine PGNs to NMEA 0183 sentences?

Yes, the USB100 converts some of the NMEA 2000 engine PGN information into NMEA 0183 sentences. Please refer to the document entitled “USB100 Engine Sentences.pdf”, which can be found below in the Attachments section.

Attachments (1) Attachments
Related Articles RSS Feed
Does the USB100 work with Mac OS/X?
Viewed 4335 times since Mon, Dec 14, 2009
My USB100’s COM port is in use by the navigational program on my PC. Can N2KView use the same COM port?
Viewed 4706 times since Mon, Nov 17, 2008
What are the voltage specifications for each Maretron device?
Viewed 7574 times since Thu, Dec 22, 2011
GWUtilities and USB100 drivers
Viewed 3994 times since Mon, May 16, 2011
What firmware changes have taken place on the Maretron USB100?
Viewed 4039 times since Mon, May 16, 2011
What type of information can be viewed on Maretron’s display products, and what products are required to generate the data to be displayed?
Viewed 24629 times since Tue, Oct 25, 2011
What is GWUtilities used for?
Viewed 1929 times since Fri, Jun 26, 2015
Does Maretron have a Linux driver for the USB100?
Viewed 19148 times since Fri, Sep 11, 2009
How can I tell which messages (PGNs) are being sent on the J1939 bus by an engine or genset?
Viewed 3298 times since Thu, Jun 23, 2011
Using N2KAnalyzer, how do I recover a Maretron device?
Viewed 4592 times since Thu, Dec 22, 2011
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.