Knowledge Base
Home » Categories » Multiple Categories

How do I create or edit a Favorite screen using the Maretron DSM150, DSM200, or DSM250?

Enter menu mode, scroll to "Favorite Screen Setup..." and press enter. Scroll to the favorite screen where you would like to set your data info and press enter. Scroll to "Data:" and press enter. Scroll to the data type you wish to display and press enter. Scroll to the data information you wish to display and press enter. Press the back key three times to exit menu mode and return to the normal viewing mode. Scroll through your screens to the favorite screen you selected for the data information. You may edit any screen in the same way as described.

Attachments (2) Attachments
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Installation Offset Calibration?"; what is this?
Viewed 2702 times since Thu, Jun 19, 2008
I want to update my NMEA 2000 network to include fuel management data; which Maretron devices do I need?
Viewed 11522 times since Fri, Mar 8, 2013
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Status?"; what is this?
Viewed 2652 times since Thu, Jun 19, 2008
What is the SMS100 Status message? Which Maretron components do I need?
Viewed 4719 times since Thu, Jun 6, 2013
How do I display the GPS100 moon phase on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2942 times since Tue, Jun 17, 2008
How do I display the J2K100 engine percent load on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3334 times since Thu, Jan 14, 2010
How do I display the GPS100 sunrise time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2791 times since Tue, Jun 17, 2008
How do I display the WSO100 apparent wind on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3580 times since Thu, Jul 10, 2008
How do I display the J2K100 engine coolant temperature on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3207 times since Sat, Jun 25, 2011
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3067 times since Fri, Jul 11, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.