Knowledge Base
Home » Categories » Multiple Categories

How do I calibrate the SSC200 pitch to read zero using Maretron’s DSM150, DSM200, or DSM250 display?

You can calibrate the SSC200 pitch to read zero when the vessel is sitting flat in the water using a DSM150, DSM200, or DSM250 display. To zero the pitch, enter menu mode, scroll to "Configuration..." and press enter. Scroll to "Device Configuration..." and press enter. Scroll to the SSC200 and press enter. Scroll to "Installation Offset Calibration..." and press enter. Even though it appears that you are aligning the compass, go ahead and press enter. Pressing enter not only sets the alignment of the compass but it also zeros both the pitch and roll.
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Status?"; what is this?
Viewed 2139 times since Thu, Jun 19, 2008
How do I set the RAA100 configuration setting called "Gauge Resistance, + to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2751 times since Fri, Jul 11, 2008
How do I display the GPS100 local date on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2406 times since Tue, Jun 17, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Speed Calibration..."; what is this?
Viewed 2522 times since Sun, Jun 22, 2008
What is the default calibration setting for the RAA100?
Viewed 2568 times since Fri, Jul 11, 2008
How do I reset the GPS100 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 2500 times since Tue, Jun 17, 2008
How do I display the GPS100 local time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2417 times since Tue, Jun 17, 2008
What Yanmar engine models is the EMS100 compatible with?
Viewed 12029 times since Thu, Mar 27, 2014
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Levels Calibration..."; what is this?
Viewed 2128 times since Mon, Jun 29, 2009
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Capacity:"; what is this?
Viewed 2393 times since Thu, Jun 19, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.