Knowledge Base
Home » Categories » Multiple Categories

Why doesn’t my rudder display read hard over when the rudder is hard over?

The rudder display may not read hard over even though the rudder is hard over if the resistive sensor is not turning throughout its entire range. You can fix this by either adjusting the resistive sensor to turn across its entire range or you can perform a custom calibration of the RAA100 using a Maretron DSM150, DSM200, or DSM250.
Attachments (2) Attachments
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a WSO100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2455 times since Sat, Aug 2, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2671 times since Sat, Jul 19, 2008
How do I display the WSO100 apparent wind on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3587 times since Thu, Jul 10, 2008
I see that Maretron’s DSM150, DSM200 and DSM250 displays have TLA100 configuration settings called "Gauge Resistance, + to sender:" and "Gauge Resistance, - to sender:"; what are these?
Viewed 3451 times since Mon, Jun 25, 2012
What Yanmar engine models is the EMS100 compatible with?
Viewed 19782 times since Thu, Mar 27, 2014
How do I display the TLA100 tank level on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3268 times since Wed, Jul 9, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 2572 times since Fri, Jun 20, 2008
How do I display UTC from the GPS100 on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3275 times since Mon, Jun 25, 2012
How do I display the J2K100 engine percent load on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3337 times since Thu, Jan 14, 2010
How do I display the J2K100 engine fuel pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3598 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.