Knowledge Base
Home » Categories » Navigation Instruments » RAA100

If the RAA100 is connected and configured to operate in the "NMEA 2000 & Analog Gauge" mode, how do I connect the wires to the back of the analog gauge?

You connect the RAA100 operating in the "NMEA 2000 & Analog Gauge" mode to the gauge in the following way:

  1. connect the black wire to the gauge ground terminal
  2. connect the green wire to the gauge sensor terminal
  3. connect the red wire to the gauge power terminal
Attachments (2) Attachments
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.