Knowledge Base
Home » Categories » Navigation Instruments » RAA100

If the RAA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?

You connect the RAA100 operating in the NMEA 2000 mode (i.e., without analog gauge) to a resistive sensor in the following way:

  1. connect the black wire to the sensor ground terminal
  2. connect the white wire to the sensor positive terminal
Attachments (2) Attachments
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.