Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?

Article Number: 281 | Rating: Unrated | Last Updated: Fri, Jul 11, 2008 5:42 PM

Yes, it is possible to set the RAA100 to accept American standard resistive sensors using Maretron's DSM150, DSM200, or DSM250 display. Set the mode using Maretron's DSM150, DSM200, or DSM250 display in the following way. Enter menu mode, scroll to "Configuration…" and press enter. Scroll to "Device Configuration…" and press enter. Scroll to the row containing the RAA100 and press enter. Scroll to "Rudder Angel Calibration:" and press enter. Scroll until you find "American Standard (240-33ohms)" and press enter.

Attachments (2)

Attachments

RAA100UM_1.0.pdf ( 385 Views, 0 Bytes )
DSM250UM_1.0.pdf ( 372 Views, 0 Bytes )

Related Articles

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Operating Mode:"; what is this?

Viewed 1990 times since Thu, Jun 19, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Capacity:"; what is this?

Viewed 2065 times since Thu, Jun 19, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Installation Offset Calibration?"; what is this?

Viewed 1964 times since Thu, Jun 19, 2008

Which Maretron products are necessary in order to display apparent wind?

Viewed 3198 times since Wed, Apr 10, 2013

How do I display the DST100 trip log using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 1889 times since Sun, Jun 22, 2008

What are the voltage specifications for each Maretron device?

Viewed 4876 times since Thu, Dec 22, 2011

How do I display the J2K100 generator average line-line AC voltage on Maretron’s DSM150 or DSM250 display?

Viewed 2571 times since Thu, Jan 14, 2010

How do I set up my SMS100 address book using Maretron displays?

Viewed 2110 times since Thu, Jun 6, 2013

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "Reset Factory Defaults"; what is this?

Viewed 2053 times since Thu, Mar 5, 2009

How do I reset the RAA100 to send the factory default messages (or PGNs)?

Viewed 2321 times since Fri, Jul 11, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.