Knowledge Base
Home » Categories » Multiple Categories

How do I set the RAA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?

Article Number: 278 | Rating: Unrated | Last Updated: Thu, Jul 10, 2008 1:26 PM
You set the RAA100 "Gauge Resistance, - to sender" using Maretron's DSM150, DSM200, or DSM250 display in the following way. Enter menu mode, scroll to "Configuration…" and press enter. Scroll to "Device Configuration…" and press enter. Scroll to the row containing the RAA100 and press enter. Scroll to "Gauge Resistance, - to sender":" and press enter. Scroll until you find the appropriate resistance and press enter.
Posted - Thu, Jul 10, 2008 1:26 PM. This article has been viewed 2353 times.
Filed Under: DSM250, DSM410, RAA100
Attachments (2) Attachments
Related Articles RSS Feed
What is the RAA100 configuration setting "operating mode"?
Viewed 2131 times since Thu, Jul 10, 2008
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2400 times since Fri, Jul 11, 2008
Can I turn On and Off loads connected to the DCR100 using the DSM150 or DSM250?
Viewed 2570 times since Thu, May 5, 2011
Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 1987 times since Fri, Jun 20, 2008
Why I can’t find a RAA100 rudder angle for display on Maretron’s DSM150, DSM200, or DSM250?
Viewed 3172 times since Fri, Jul 11, 2008
Does Maretron offer quick setup instructions for the FFM100 in a single diesel engine application?
Viewed 4674 times since Tue, Jul 29, 2014
How do I display the J2K100 engine percent load on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2579 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Zero Offset Calibration..."; what is this?
Viewed 2042 times since Sat, Jul 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Speed Calibration..."; what is this?
Viewed 2343 times since Sun, Jun 22, 2008
How do I set the J2K100 configuration setting called "J1939 Source Address:" using Maretron’s DSM150 or DSM250 display?
Viewed 2803 times since Thu, Jan 14, 2010
  • Icon SubscriberSubscribe to Article
  • Icon PrinterPrint Article
  • Icon EmailEmail Article to Friend
  • Icon PDFExport to PDF
  • Icon MS-WordExport to MS Word
0 (0)
Article Rating (0 Votes)
Rate this article
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.
 
Copyright© 2019 Carling Technologies. All rights reserved. Visit Carling Technologies, a partner company.