Knowledge Base
Home » Categories » Multiple Categories

How do I set the RAA100 configuration setting called "Gauge Resistance, + to sender" using Maretron’s DSM150, DSM200, or DSM250 display?

You set the RAA100 "Gauge Resistance, + to sender" using Maretron's DSM150, DSM200, or DSM250 display in the following way. Enter menu mode, scroll to "Configuration…" and press enter. Scroll to "Device Configuration…" and press enter. Scroll to the row containing the RAA100 and press enter. Scroll to "Gauge Resistance, + to sender":" and press enter. Scroll until you find the appropriate resistance and press enter.
Attachments (2) Attachments
Related Articles RSS Feed
How do I display the WSO100 apparent wind on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3585 times since Thu, Jul 10, 2008
Which Maretron products are necessary in order to display apparent wind?
Viewed 4046 times since Wed, Apr 10, 2013
If the RAA100 is connected and configured to operate in the "NMEA 2000" mode (i.e., without an analog gauge), how do I connect the wires to the resistive sensor?
Viewed 2339 times since Thu, Jul 10, 2008
How do I clear the WSO100 atmospheric pressure offset using Maretron’s DSM150 or DSM250 display?
Viewed 3542 times since Sat, Aug 2, 2008
Why I can’t find a RAA100 rudder angle for display on Maretron’s DSM150, DSM200, or DSM250?
Viewed 3795 times since Fri, Jul 11, 2008
Can I custom calibrate the RAA100 for non-standard resistance sensors or can I do custom calibration for hard over points other than 60 degrees?
Viewed 2711 times since Thu, Jul 10, 2008
What is the SMS100 Status message? Which Maretron components do I need?
Viewed 4721 times since Thu, Jun 6, 2013
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Tank Capacity:"; what is this?
Viewed 2846 times since Thu, Jun 19, 2008
How do I display the J2K100 engine coolant temperature on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3209 times since Sat, Jun 25, 2011
I navigate using magnetic heading and not true heading; how do I use the SSC200 compass and Maretron’s DSM150, DSM200, or DSM250 display to view my heading in magnetic?
Viewed 3427 times since Thu, Jun 19, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.