Knowledge Base
Home » Categories » Navigation Instruments » RAA100

What is the RAA100 configuration setting "Gauge Resistance, + to sender" and "Gauge Resistance, - to sender"?

If the RAA100's operating mode is set to "NMEA 2000 & Analog Gauge", then it is important to configure the RAA100 with the gauge's resistances in order for the RAA100 to operate correctly. Please refer to the RAA100 User's Manual for a detailed description of measuring the gauge's resistance values.

Attachments (2) Attachments
Related Articles RSS Feed
Using N2KAnalyzer, how do I recover a Maretron device?
Viewed 2011 times since Thu, Dec 22, 2011
What messages (or PGNs) does the RAA100 transmit?
Viewed 2355 times since Fri, Jul 11, 2008
What is an RAA100?
Viewed 2453 times since Fri, Jul 11, 2008
Can Maretron’s sensor data be displayed on a Furuno CANBUS network?
Viewed 1267 times since Mon, Jun 12, 2017
Why I can’t find a RAA100 rudder angle for display on Maretron’s DSM150, DSM200, or DSM250?
Viewed 3082 times since Fri, Jul 11, 2008
What firmware changes have taken place on the Maretron RAA100?
Viewed 1786 times since Mon, May 16, 2011
What is the default calibration setting for the RAA100?
Viewed 2283 times since Fri, Jul 11, 2008
What type of rudder senders does the RAA100 work with?
Viewed 678 times since Thu, Jul 10, 2008
Is it possible to turn on or off RAA100 transmitted messages (or PGNs)?
Viewed 2265 times since Fri, Jul 11, 2008
Can I use the RAA100 if my hard over points are not 60 degrees?
Viewed 1726 times since Fri, Jul 11, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.