Knowledge Base
Home » Categories » Multiple Categories

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"; what is this?

Maretron's DSM150, DSM200,and DSM250 displays have a J2K100 configuration setting called "J1939 Diagnostic Messages:"  which is used to configure the J2K100 to pass diagnostic messages from the J1939 network through to the NMEA 2000 network. Normally, the J2K100 blocks all J1939 diagnostic messages, although this setting allows the diagnostic messages to be passed through to the NMEA 2000 network.

Attachments (1) Attachments
Related Articles RSS Feed
How do I set the J2K100 configuration setting called "NMEA 2000 Transmission Instance:" using Maretron’s DSM150 or DSM250 display?
Viewed 2280 times since Thu, Jan 14, 2010
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2282 times since Fri, Jul 11, 2008
Why doesn’t my rudder display read hard over when the rudder is hard over?
Viewed 2399 times since Thu, Jul 10, 2008
I see that Maretron’s DSM150 and DSM250 displays have a SSC200 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?
Viewed 1909 times since Thu, Jun 19, 2008
What is a J2K100?
Viewed 2582 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Calibration?"; what is this?
Viewed 2067 times since Thu, Jun 19, 2008
How do I display the GPS100 sunset time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 1918 times since Tue, Jun 17, 2008
How do I display the J2K100 transmission oil temperature on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2431 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200 and DSM250 displays have a WSO100 configuration setting called "Installation Offset Calibration..."; what is this?
Viewed 2658 times since Mon, Jul 21, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Source Address:"; what is this?
Viewed 1917 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.