Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

How do I display the J2K100 generator average line-neutral AC RMS voltage on Maretron’s DSM150 or DSM250 display?

Article Number: 239 | Rating: Unrated | Last Updated: Mon, Jun 2, 2014 9:52 PM

You display the J2K100 generator average line-neutral AC voltage on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press enter. Scroll to the favorite screen where you would like to view the voltage and press enter. Scroll to "Data:" and press enter. Scroll to "AC Power #x" where x is the instance you want to view (instance 2 might be the port generator and instance 3 might be the starboard generator) and press enter. Scroll to "Gen. Avg. L-N AC Voltage" and press enter. Press the back key three times to exit menu mode and return to the normal viewing mode. Scroll through your screens to the favorite screen you selected for voltage.

Attachments (1)

Attachments

J2K100UM_1.2.pdf ( 357 Views, 0 Bytes )

Related Articles

What information is available from the fluid pressure monitor (FPM100) and can be viewed on Maretron’s displays?

Viewed 2140 times since Fri, Jun 21, 2013

How do I display the J2K100 generator average AC frequency on Maretron’s DSM150 or DSM250 display?

Viewed 2362 times since Thu, Jan 14, 2010

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Source Address:"; what is this?

Viewed 1927 times since Thu, Jan 14, 2010

What marine engines are found to have J1939 capability?

Viewed 8366 times since Mon, Jul 16, 2012

What is the default calibration setting for the TLA100?

Viewed 2314 times since Fri, Jun 20, 2008

How do I display the GPS100 latitude and longitude or position using Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2051 times since Sun, Jun 22, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a WSO100 configuration setting called "Reset Factory Defaults"; what is this?

Viewed 1745 times since Sat, Aug 2, 2008

How do I reset the SSC200 to send the factory default NMEA 2000 messages (or PGNs)?

Viewed 1922 times since Thu, Jun 19, 2008

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a GPS100 configuration setting called "Reset Factory Defaults"; what is this?

Viewed 2028 times since Thu, Mar 5, 2009

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?

Viewed 1768 times since Fri, Jun 20, 2008

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.