Knowledge Base
Home » Categories » Multiple Categories

How do I display the J2K100 generator average line-line AC voltage on Maretron’s DSM150 or DSM250 display?

You display the J2K100 generator average line-line AC voltage on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press enter. Scroll to the favorite screen where you would like to view the voltage and press enter. Scroll to "Data:" and press enter. Scroll to "AC Power #x" where x is the instance you want to view (instance 2 might be the port generator and instance 3 might be the starboard generator) and press enter. Scroll to "Gen. Avg. L-L AC Voltage" and press enter. Press the back key three times to exit menu mode and return to the normal viewing mode. Scroll through your screens to the favorite screen you selected for voltage.
Attachments (3) Attachments
Related Articles RSS Feed
I have an Onan generator with a power rating between 4-32kW; what Maretron adapter cable should I order to connect the generator to the J2K100?
Viewed 3696 times since Mon, Jun 25, 2012
How do I display the J2K100 engine percent load on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2824 times since Thu, Jan 14, 2010
Can I use the J2K100 together with Onan generators?
Viewed 2486 times since Thu, Jan 14, 2010
How do I display the J2K100 engine fuel pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2704 times since Thu, Jan 14, 2010
Is it possible to turn on or off RAA100 transmitted messages (or PGNs)?
Viewed 2524 times since Fri, Jul 11, 2008
Does Maretron offer a Quick Setup guide for the SIM100 using N2KAnalyzer?
Viewed 1834 times since Tue, May 5, 2015
How do I make a custom NMEA 2000 cordset cable? Does Maretron offer a field attachable connector?
Viewed 10096 times since Wed, Oct 10, 2012
I know the J2K100 receives messages from the J1939 network and subsequently transmits them over the NMEA 2000 network, but does the J2K100 transmit any messages on the J1939 network?
Viewed 2545 times since Thu, Jan 14, 2010
Can I set the RAA100 to accept the European standard for resistance values (i.e. 10 to 180 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2531 times since Thu, Jul 10, 2008
How do I set the RAA100 configuration setting called "Gauge Resistance, + to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2753 times since Fri, Jul 11, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.