Knowledge Base
Home » Categories » Multiple Categories

How do I display the J2K100 engine fuel pressure on Maretron’s DSM150, DSM200, or DSM250 display?

You display the J2K100 engine fuel pressure on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press enter. Scroll to the favorite screen where you would like to view the fuel pressure and press enter. Scroll to "Data:" and press enter. Scroll to "Engine #x" where x is the engine instance you want to view (instance 0 is single or port engine and instance 1 is the starboard engine) and press enter. Scroll to "Fuel Pressure" and press enter. Press the back key three times to exit menu mode and return to the normal viewing mode. Scroll through your screens to the favorite screen you selected for fuel pressure.
Attachments (3) Attachments
Related Articles RSS Feed
How do I set the J2K100 configuration setting called "NMEA 2000 Transmission Instance:" using Maretron’s DSM150 or DSM250 display?
Viewed 3642 times since Thu, Jan 14, 2010
How do I calibrate the SSC200 pitch to read zero using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2951 times since Fri, Jul 18, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Damping Period:"; what is this?
Viewed 2763 times since Thu, Jun 19, 2008
I want to update my NMEA 2000 network to include fuel management data; which Maretron devices do I need?
Viewed 11529 times since Fri, Mar 8, 2013
Can I set the TLA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2606 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Reset Factory Defaults"; what is this?
Viewed 2708 times since Fri, Jun 20, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "J1939 Source Address:"; what is this?
Viewed 2869 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 Transmission Instance:"; what is this?
Viewed 3218 times since Thu, Jan 14, 2010
What are the basic configurable parameters for a J2K100 and how do I configure them using a DSM250?
Viewed 3684 times since Thu, Jan 14, 2010
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3069 times since Fri, Jul 11, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.