Knowledge Base
Home » Categories » Multiple Categories

How do I display the J2K100 engine oil temperature on Maretron’s DSM150, DSM200, or DSM250 display?

You display the J2K100 engine oil temperature on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press enter. Scroll to the favorite screen where you would like to view the oil temperature and press enter. Scroll to "Data:" and press enter. Scroll to "Engine #x" where x is the engine instance you want to view (instance 0 is single or port engine and instance 1 is the starboard engine) and press enter. Scroll to "Oil Temperature" and press enter. Press the back key three times to exit menu mode and return to the normal viewing mode. Scroll through your screens to the favorite screen you selected for oil temperature.
Attachments (3) Attachments
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 Transmission Instance:"; what is this?
Viewed 1773 times since Thu, Jan 14, 2010
How do I reset the TLA100 to send the factory default messages (or PGNs)?
Viewed 1818 times since Fri, Jun 20, 2008
How do I set the TLA100 tank type using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2405 times since Fri, Jun 20, 2008
Why does the SSC200 rate of turn indicate that I am turning when I am not turning?
Viewed 1914 times since Thu, Jun 19, 2008
How do I display the DST100 trip log using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 1933 times since Sun, Jun 22, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Variation Source:"; what is this?
Viewed 2188 times since Thu, Jun 19, 2008
How do I make a custom NMEA 2000 cordset cable? Does Maretron offer a field attachable connector?
Viewed 8726 times since Wed, Oct 10, 2012
How do I display the J2K100 transmission oil pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2579 times since Thu, Jan 14, 2010
How do I set the RAA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2288 times since Thu, Jul 10, 2008
How do I set the J2K100 configuration setting called "J1939 Diagnostic Messages:" using Maretron’s DSM150 or DSM250 display?
Viewed 2274 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.