Knowledge Base
Home » Categories » Multiple Categories

How do I display the J2K100 engine boost pressure on Maretron’s DSM150, DSM200, or DSM250 display?

You display the J2K100 engine boost pressure on a DSM150, DSM200, or DSM250 in the following way. Enter menu mode, scroll to "Favorite Screen Setup..." and press enter. Scroll to the favorite screen where you would like to view the boost pressure and press enter. Scroll to "Data:" and press enter. Scroll to "Engine #x" where x is the engine instance you want to view (instance 0 is single or port engine and instance 1 is the starboard engine) and press enter. Scroll to "Boost Pressure" and press enter. Press the back key three times to exit menu mode and return to the normal viewing mode. Scroll through your screens to the favorite screen you selected for boost pressure.
Attachments (2) Attachments
Related Articles RSS Feed
How do I display the GPS100 twilight PM time on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 1875 times since Tue, Jun 17, 2008
I know the J2K100 receives messages from the J1939 network and subsequently transmits them over the NMEA 2000 network, but does the J2K100 transmit any messages on the J1939 network?
Viewed 2065 times since Thu, Jan 14, 2010
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Magnetic Deviation Status?"; what is this?
Viewed 1829 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a DST100 configuration setting called "Clear Speed Calibration:"; what is this?
Viewed 2227 times since Sun, Jun 22, 2008
Can I use the DCR100 to turn on my Marine Audio Amplifier ?
Viewed 1032 times since Tue, Jul 19, 2016
What type of tank senders does the TLA100 work with?
Viewed 2186 times since Fri, Jun 20, 2008
What are the latest changes that have been made to DSM410?
Viewed 519 times since Wed, May 17, 2017
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 Transmission Instance:"; what is this?
Viewed 1706 times since Thu, Jan 14, 2010
What are the operating modes of the DSM250?
Viewed 2186 times since Tue, Oct 6, 2009
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Damping Period:"; what is this?
Viewed 1978 times since Thu, Jun 19, 2008
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.