Knowledge Base
Home » Categories » Multiple Categories

How do I display the J2K100 engine speed or tachometer on Maretron’s DSM150, DSM200, or DSM250 display?

You display the J2K100 tachometer on a DSM150, DSM200, or DSM250 in the following way.

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view the tachometer and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "Engine #x" where x is the engine instance you want to view (instance 0 is single or port engine and instance 1 is the starboard engine) and press < Enter >
  5. Scroll to "Tachometer" and press < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode
  7. Scroll through your screens to the favorite screen you selected for tachometer
Attachments (2) Attachments
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Rate of Turn Damping Period:"; what is this?
Viewed 2092 times since Thu, Jun 19, 2008
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a TLA100 configuration setting called "Operating Mode:"; what is this?
Viewed 2106 times since Thu, Jun 19, 2008
What firmware changes have taken place on the Maretron DSM200?
Viewed 3273 times since Tue, Jan 17, 2012
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a SSC200 configuration setting called "Variation Source:"; what is this?
Viewed 2242 times since Thu, Jun 19, 2008
Can I do a custom calibration for non-standard resistance sensors or odd shaped tanks?
Viewed 2199 times since Thu, Jun 19, 2008
I know the J2K100 receives messages from the J1939 network and subsequently transmits them over the NMEA 2000 network, but does the J2K100 transmit any messages on the J1939 network?
Viewed 2244 times since Thu, Jan 14, 2010
How do I calibrate the SSC200 pitch to read zero using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2326 times since Fri, Jul 18, 2008
Can the J2K100 connect to third party protocol converters that support J1708 or J1587?
Viewed 8550 times since Fri, Aug 29, 2014
How do I set the TLA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2331 times since Fri, Jun 20, 2008
How do I display the J2K100 engine fuel pressure on Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 2489 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.