Knowledge Base

KB Home | Search | Glossary | Ask Question |

English

Where would I use a J2K100?

Article Number: 221 | Rating: Unrated | Last Updated: Mon, Jun 2, 2014 9:55 PM

You use the J2K100 if you have a propulsion engine or a generator that has a J1939 network connection and you want to display engine or electrical information on an NMEA 2000 compatible display.

Attachments (1)

Attachments

J2K100UM_1.2.pdf ( 362 Views, 0 Bytes )

Related Articles

Can the J2K100 connect to third party protocol converters that support J1708 or J1587?

Viewed 7297 times since Fri, Aug 29, 2014

Do gasoline engines with an electronic control module (ECM) have J1939 compatibilities?

Viewed 6564 times since Fri, Feb 17, 2012

Can Maretron devices be displayed on a Raymarine Seatalk NG network?

Viewed 2628 times since Wed, Feb 25, 2015

How do I display the J2K100 transmission oil pressure on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2496 times since Thu, Jan 14, 2010

I see that Maretron’s DSM150, DSM200, and DSM250 displays have a J2K100 configuration setting called "NMEA 2000 PGN Enable/Disable..."; what is this?

Viewed 2164 times since Thu, Jan 14, 2010

How do I perform J2K100 quick setup using the N2KAnalyzer program?

Viewed 4974 times since Wed, Oct 10, 2012

How do I display the J2K100 generator average line-neutral AC RMS voltage on Maretron’s DSM150 or DSM250 display?

Viewed 2667 times since Thu, Jan 14, 2010

How do I display the J2K100 engine fuel rate on Maretron’s DSM150, DSM200, or DSM250 display?

Viewed 2757 times since Thu, Jan 14, 2010

How do I reset the J2K100 to send the factory default NMEA 2000 messages (or PGNs)?

Viewed 2281 times since Thu, Jan 14, 2010

How do I connect the Dometic Q-logic controller to the J2K100 for N2KView control?

Viewed 1806 times since Thu, Feb 23, 2017

Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.