Knowledge Base
Home » Categories » Multiple Categories

How do I display the WSO100 apparent wind on Maretron’s DSM150, DSM200, or DSM250 display?

You display the WSO100 apparent wind on a DSM150, DSM200, or DSM250 in the following way.

  1. Enter menu mode, scroll to "Favorite Screen Setup..." and press < Enter >
  2. Scroll to the favorite screen where you would like to view the apparent wind and press < Enter >
  3. Scroll to "Data:" and press < Enter >
  4. Scroll to "Wind" and press < Enter >
  5. Scroll to either "Dir. Apparent" or "Speed Apparent" and pressĀ  < Enter >
  6. Press the < Back > key three times to exit menu mode and return to the normal viewing mode
  7. Scroll through your screens to the favorite screen you selected for apparent wind.
Attachments (2) Attachments
Related Articles RSS Feed
I see that Maretron’s DSM150, DSM200, and DSM250 displays have a WSO100 configuration setting called "Barometric Pressure:"; what is this?
Viewed 3027 times since Wed, Jun 25, 2008
What type of information can be viewed on Maretron’s display products, and what products are required to generate the data to be displayed?
Viewed 24618 times since Tue, Oct 25, 2011
Does Maretron offer a Quick Setup guide for the SIM100 using N2KAnalyzer?
Viewed 3182 times since Tue, May 5, 2015
How do I display the DC Time Remaining on the DSM150 or DSM250 display?
Viewed 2975 times since Fri, Nov 7, 2008
How do I display the GPS Course Over Ground (COG) using Maretron’s DSM150 or DSM250 display?
Viewed 4500 times since Tue, Jun 17, 2008
How do I set the TLA100 configuration setting called "Gauge Resistance, + to sender:" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3192 times since Mon, Jun 25, 2012
How do I clear the WSO100 outside humidity offset using Maretron’s DSM150 or DSM250 display?
Viewed 2864 times since Sat, Aug 2, 2008
How do I set the RAA100 configuration setting called "Gauge Resistance, - to sender" using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3037 times since Thu, Jul 10, 2008
Can I set the RAA100 to accept the American standard for resistance values (i.e. 240 to 33 ohms) using Maretron’s DSM150, DSM200, or DSM250 display?
Viewed 3069 times since Fri, Jul 11, 2008
How do I reset the J2K100 to send the factory default NMEA 2000 messages (or PGNs)?
Viewed 3228 times since Thu, Jan 14, 2010
Subscribe to knowledgebase
Get notified when new articles are added to the knowledgebase.